[M4IF Technotes] re: doubt

[Rob Koenen]

-----Original Message-----
From: Wollborn Michael (FV/SLM) * [mailto:Michael.Wollborn   de.bosch.com]
Sent: Thursday, 07 June, 2001 5:41
To: 
Cc: 'Rob Koenen'
Subject: 
Dear Jeyur,
> We would like to know the Visual Profile and Level 
> implementated in these
> Reference Software.
> 
> Does it support Visual Simple Profile @ Level 3 ?

the version 1 Reference Software should support all profiles defined in the
version 1 of the Standard. Hence, regarding your question, it should also
support the Visual Simple Profile. With respect to levels things get more
complex, since the reference software was not designed to test conformance.
And since it is a software solution, some parameters defined in the level
may not apply. Therefore, I think the correct answer with this respect is
that you can not really say it supports a certain level, since that also
depends on the hardware used etc.
Hope this helps. If you have any further related question don't hesitate to
ask.
Best Regards,
	Michael
_______________________________________________________________________
Dipl.-Ing. Dipl.-Wirt.-Ing. Michael Wollborn
Robert Bosch GmbH         Phone: +49 5121 49 5017
FV/SLM, PO Box 777777     Fax:   +49 5121 49 17 5017
31132 Hildesheim          Email: Michael.Wollborn   de.bosch.com
Germany                   http://www.tnt.uni-hannover.de/~wollborn
_______________________________________________________________________
"It follows that the Scientist, like the Pilgrim, must wend a straight 
 and narrow path between the Pitfalls of Oversimplification and the 
 Morass of Overcomplication" - Richard Bellman
_______________________________________________________________________